What is Ground Water?

Ground water is water below the land surface that fills the spaces between grains of sediment and rocks, or fills cracks and fractures in the rock.  Saturated zones in sediment such as sand and gravel, and in fractured rock formations, that receive, store, and transmit water to wells are called aquifers.
 Clean and plentiful ground water is a vital resource for personaland economic health everywhere in the United States.  Each day, over130 million Americans get their drinking water from ground water. About 40 million are supplied from individual home wells.
 Ground water is a safe, economic and environmentally friendly resource.  We don’t need to dam up rivers and disturb ecology to storewater.  Mother Nature has made the rocks of the earth as a natural storage place for ground water.  We can all play a role in protecting America’s ground water.  Private well owners have a special responsibility to ensure the safety of their drinking water.

The Hydrologic Cycle:

    Water in aquifers comes from rain and melted snow that filters through the soil.  As the water moves down, plants consume aportion, some is evaporated, and some is retained by the soil. The rest seeps downwards, usually very slowly, to add water to the aquifer. This process is part of the hydrologic cycle.  The amount and quality of groundwater varies from place to place both within individual states and from state to state, because geology, climate, and land use are different.

    The quality of water from wells can be influenced by:

• Natural factors, such as the type of rock, gravel, sand or soil.
• Or by pollution, for example, from poorly managed agriculture, inferior septic systems or community waste disposal sites.

How do we get Ground Water?

 In most cases, a water well is needed to reach the aquifer where ground water is found.  Today, most wells are made by drilling into the rock layers using drilling machines (rigs) to access water deep beneath the surface.  In most cases electric pumps are used to raise the water to the surface.
 The creation of a water well consists of several elements. After selecting the site to drill the well, the process usually includes drilling, development, testing and equipment installation.
 A water well is a specially engineered hole in the ground. It should be located and constructed in a manner which meets all codes and guidelines.  Proper construction and location is of most importance, to help ensure safe drinking water.  Your County health officers, local code enforcers and ground water contractors can give you advice on proper well location and construction.

How much Water do you need?

If you plan wisely, a good, dependable water well can supply you with all the water you need now and in the future.  A rule of thumb is to allow for between 75 and 150 gallons per person per day.  You need to take into account the peak demand, for example when there may be extra guests.
 The amount of water expected for domestic supply is usually 4-10gallons per minute.  However, with an adequate storage tank, a well producing as little as one gallon per minute can be sufficient for domestic needs.  In many wells, several hundred gallons of water are already stored in the well column.  For every foot of a 6 inch diameter well below water level,there are about 1½ gallons of water.
 Outside use of water can pose much greater demands.  You need to calculate the required well yield if your well is needed for additional water uses such as: swimming pool, lawn and garden irrigation, fire protection, etc.

Some Facts to remember:

•  Studies show that most Americans would prefer their own private waterwell.
•  You can decide how to treat your well water if you so desire.
•  You may not ever have to worry about water restrictions.
•  A good, properly constructed water well will be an asset to your property.
•  After the initial cost of installing a well and pump system, your water is virtually free.  Even with budgeting for future service, it will more than likely be less expensive than pipe line water.